fpc连接器fpc插座fpc连接座fpc插座连接器ffc连接器ffc插座ffc插座连接器ffc插头座 产 品 规 格 书product specification【1】适用范围scope本规格书适用于：0.5间距柔性扁平电缆连接器（有锁式）this specification covers the 0.5mm pitch fpc/ffc connectors（series locking）【2】产品名称及型号product name and part number产品名称product name 产品型号part numberffc/fpc扁平电缆连接器 【3】定格ratings项目 item 规 格 requirement大容许电压rated voltage(max) 50v [ac/dc(有效值virtual value)50hz]大容许电流rated current(max) 0.4a使用温度范围ambient temperature range -25℃～+85℃ 【4】性能performance4.1电气性能electrical performance项目item 条 件 test condition 规格requirement4.1.1 接触电阻contact resistance 适合fpc/ffc嵌合；开放电压20mv以下；短路电流10ma的状态下测定。mate applicable fpc/ffc and measure by dry circuit，20mv max，10ma. ≤20 mωmax4.1.2 绝缘电阻insulation resistance 适合fpc/ffc嵌合；相邻端子间或端子与地面间加dc 500v下测定。mate applicable fpc/ffc and apply 500v dc between adjacent terminal or ground. 500mωmin4.1.3 耐电压dielectric 适合fpc/ffc嵌合；相邻端子间或端子与地面间加ac 200v（有效值）历时1分钟下测定。mate applicable fpc/ffc and apply 200v ac（virtual value）for 1minute between adjacent terminal or ground. 无击穿现象no breakdown4.2机械性能mechanical performance项目item 条 件 test condition 规格requirement4.2.1 锁紧力及拔出力locking and withdrawal force适合0.3mm厚的ffc；用每分钟25±3mm的速度；平行地插入、锁紧、拔出。insert and extract applicable ffc at the speed rate of 25±3mm/minute. 锁紧力locking1.96*n (n) max拔出力withdrawal0.49*n (n) min4.2.2 端子保持力terminal /housing retention force 以用每分钟25±3mm的速度平行向外拉pull the terminal at the speed rate of 25±3mm per minute 3.92n min 4.3环境和其他性能environmental performance and others项目item 条 件 test condition 规格requirement 4.3.1 重复插拔repeated insertion and withdrawal 无通电状态；以10次/分钟的速度插拔20次insertion and withdrawal actuator up to 20 cycles at the speed rate of less than 10 cycles/minute 接触抵抗contact resistance 60 mωmax4.3.2 温度上升temperature rise 适合fpc/ffc嵌合；大容许电流通电，温度测定。（ul 498）carrying rated current load.（ul 498） 温度上升temperature rise 30℃max项目item 条 件 test condition 规格requirement4.3.3 耐振动性vibration dc 1ma通电状态下；嵌合轴沿xyz三个方向振动；振幅1.5mm；频率10-55-10hz/分；历时2小时amplitude：1.5mmp-psweep time：10-55-10hz in 1 minuteduration：2 hours in each x.y.z. axes 外观appearance 无损坏no damage接触抵抗contact resistance 60 mωmax瞬断discontinuity 1 ms max.4.3.4 耐冲击性shock dc 1ma通电状态下；嵌合轴沿相互垂直的6个方向；以490m/s2{50g}冲击；各3次490m/s2{50g}，3 strokes in each x.y.z. axes. 外观appearance 无损坏no damage瞬断discontinuity 1 ms max.4.3.5 耐热性heatresistance 适合fpc/ffc嵌合；85±2℃的空气中；放置96小时；再回到室温中放置1-2小时85±2℃，96 hour外观appearance 无损坏no damage接触抵抗contact resistance 60 mωmax4.3.6 耐寒性coldresistance 适合fpc/ffc嵌合；-40±2℃的空气中；放置96小时；再回到室温中放置1-2小时-40±2℃，96 hour 外观appearance 无损坏no damage接触抵抗contact resistance 60 mωmax4.3.7 耐湿性humidity 适合fpc/ffc嵌合；40±2℃、相对湿度90-95%的空气中；放置96小时；再回到室温中0.5小时内测定temperature：40±2℃relative humidity：90-95%duration：96 hours 外观appearance 无损坏no damage接触抵抗contact resistance 60 mωmax耐电压dielectricstrength 必须满足4.1.3must meet 4.1.3绝缘抵抗insulation resistance 20 mω min4.3.8 温度循环temperaturecycling 适合fpc/ffc嵌合；-55±3℃30分钟；常温常湿10-15分钟；85±2℃30分钟；常温常湿10-15分钟，循环5次。5 cycles of： a) -55±3℃ 30 minutesb) 85±2℃ 30 minutes 外观appearance 无损坏no damage接触抵抗contact resistance 60 mωmax项目item 条 件 test condition 规格requirement4.3.9 耐盐雾性salt spray 适合fpc/ffc嵌合；35±2℃、5±1%的盐水喷雾48小时；试验后常温水洗；再室温干燥。48±4 hours exposure to a salt spray from the 5±1% solution at 35±2℃. 外观appearance 无损坏、腐蚀no damage接触抵抗contact resistance 60 mωmax4.3.10 耐亚酸so2 gas 适合fpc/ffc嵌合；40±2℃、50±5ppm的亚酸中放置24小时24 hours exposure to 50±5ppm. so2 gas at 40±2℃. 接触抵抗contact resistance 60 mωmax4.3.11 耐性nh3 gas 适合fpc/ffc嵌合；浓度为28%的水容器中；放置40分钟。40 minutes exposure to nh3 gas evaporating from 28% ammonia solution 外观appearance 无损坏no damage 接触抵抗contact resistance 60 mωmax4.3.12 可焊性solder ability 端子前端基准面0.2mm处浸入235±5℃的锡槽中；历时2±0.5 sec。soldering time：2±0.5 sec.soldering temperature：235±5℃0.2 mmfrom terminal tip 沾敷性solder wetting 沾敷面积95%以上4.3.13 耐焊接热resistance tosoldering heat 端子前端基准面0.2mm处浸入260±5℃的锡槽中；历时5±0.5 sec。soldering time：5±0.5 sec.soldering temperature：260±5℃0.2 mmfrom terminal tip 外观appearance 无损坏、变形no damagereference standard ：参考单位reference unit【5】外观形状、寸法及材质product shape,dimensions and materials图面参照refer to the drawing.名称 name 材质 materials主体main body lcp(本色) ul 94v-0锁扣housing lock lcp(黑色) ul 94v-0端子sit uip磷青铜 phosphor bronze焊片contact 磷青铜 phosphor bronze备注remark 金属表面镀锡 导购推荐 品牌 国产 型号 fpc连接器fpc插座fpc连接座fpc插座连接器 种类 ffc/fpc 应用范围 pcb 接口类型 ac/dc 形状 矩形 线长 15+（mm） 制作工艺 熔接 特性 防水 接触件材质 磷青铜 绝缘体材质 lcp 芯数 4-60 针数 4-60